![]() Hardware is FastEthernet, address is 0 (bia 0019.0684. Received 66 broadcasts, 0 runts, 0 giants, 0 throttlesĨ92 packets output, 218760 bytes, 0 underrunsħ06 output errors, 0 collisions, 3 interface resetsįastEthernet3 is down, line protocol is down Reliability 185/255, txload 1/255, rxload 1/255ĥ minute input rate 0 bits/sec, 0 packets/secĥ minute output rate 1000 bits/sec, 1 packets/secĩ6 packets input, 11622 bytes, 0 no buffer Hardware is FastEthernet, address is (bia ) Received 92 broadcasts, 0 runts, 0 giants, 0 throttlesĠ input errors, 0 CRC, 0 frame, 0 overrun, 0 ignoredĠ input packets with dribble condition detectedĢ89 packets output, 26086 bytes, 0 underrunsġ69 output errors, 0 collisions, 3 interface resetsĠ output buffer failures, 0 output buffers swapped out Input queue: 0/75/0/0 (size/max/drops/flushes) Total output drops: 1ĥ minute input rate 1000 bits/sec, 2 packets/secĥ minute output rate 0 bits/sec, 0 packets/secġ279 packets input, 384906 bytes, 0 no buffer Last clearing of "show interface" counters never Last input never, output never, output hang never Usually this problem can be solved by first disabling the firewall feature on your router. This is not surprising if it can happen on multiple computers. It is possible that this firewall contains a router that is not given permission to ping packets that pass through the router. I have done "show interface" for all of the relevant interfaces:įastEthernet1 = Uplink to unmanaged switch The cause of the first Request Time Out is caused by the firewall. ![]() I am currently at work at the minute, but will let you know later if "spanning-tree portfast" does anything.īelow is the output from Pinging a PC that is connected directly to the Cisco Router - Switch interface (FE2) from a PC that goes through the unmanaged switch that is connected to the Cisco Router - Switch interface (FE1): Would this be ok or is this that is causing the ping problems?Īlso, as this is just a test/lab setup I just want to be able to successfully ping two devices that are connected to the network and know that the switch is functioning correctly before I expand and configure other things on the router. I also have the switch uplinked to an unmanaged switch. Would it be safe to assume that the integrated switch is working ok and that I can expect this because I need to do some more configuration? I want to use the FE1-FE8 as my internal switch and the ADSLoPOTS connection for a PPPoA ADSL broadband connection. VLAN Type SAID MTU Parent RingNo BridgeNo Stp BrdgMode Trans1 Trans2ġ003 tr 101003 1500 1005 0 - srb 1 1002 Here is the show run output:ġ default active Fa1, Fa2, Fa3, Fa4, Fa5, Fa6
0 Comments
Leave a Reply. |